The aggregation behavior of poly-(oxyethylene)-poly-(oxypropylene)-poly-(oxyethylene)-block-copolymers in aqueous solution

Aqueous solutions of blockcopolymers, consisting of a polyoxypropyleneblock (POP) with a polyoxyethylene-block (POE) at each side, were studied using surface and interfacial tension measurements, static and dynamic light scattering and smallangle neutron scattering techniques, electric birefringence, rheological and DSC-measurements. The compounds were commercial samples and had an approximate average composition EO20PO70EO20, EO18PO58EO18, and EO106PO69EO106. All three compounds formed micelles above a critical concentration. The size of the micellar core is determined by the length of the hydrophobic poly-propyleneoxide block. The transfer energy of a propyleneoxide unit from the aqueous to the micellar phase is about 0.3 kT at room temperature and hence a quarter of the corresponding value for a CH2-group. The aggregation number of the micelles increases strongly with increasing temperature while the hydrodynamic radius remains constant in first approximation. The smallangle neutron scattering (SANS) data show at higher concentrations a strong correlation peak. Both the SANS- and the light-scattering data can be interpreted on the basis of the theory of hard sphere particles. Solutions with a volume fraction beyond about 0.2 gellifie when the temperature is raised above a characteristic value that is at the lowest concentrations slightly above room temperature, shift to lower values with increasing concentrations. Below this gelation temperature DSC-measurements show a phase transition with enthalpies between 40J/g and 80J/g, which is probably due to the dehydration of the PO-groups; this transition can also be observed at low concentrations where no gelation takes place. The position of the correlation peak of the SANS-data is not affected by the gel formation. Some samples, however, show clear evidence of long-range order and seem therefore to consist of cubic liquid crystalline phases. The shear moduli of the gels can qualitatively be understood on the basis of hard sphere models.