Influence of Local Inhomogeneity of Thermomechanical Treatment Conditions on Microstructure Evolution in Aluminum Alloys

The influence of local inhomogeneity of the stress–strain condition on structure and texture evolution during thermomechanical treatment of aluminum alloys is studied in this work. For this purpose, laboratory rolling and plane strain tests that simulated roughing mill thermomechanical modes were performed. For all processes, the local inhomogeneity of structure evolution was estimated. For this purpose, x-ray texture analysis, EBSD and optical microscopy were used. Additionally, the calculations which allow to evaluate local inhomogeneity of stress–strain conditions for the each process were performed. The experimental results were compared with mathematical simulation output. They indicated structure and texture evolution inhomogeneities, especially during the plane strain and industrial rolling processes. In the plane strain test, typical local deformation zones occurred with different resulting grain size and texture effects than those observed in both rolling processes. This difference was mainly associated with different stress states, strain intensity and strain rate distribution throughout the deformation zone. This study demonstrated that the inhomogeneity of these parameters has a strong impact on structure and texture evolution in the first stage of thermomechanical treatment. In the center layer, laboratory rolling could adequately generate the structure and texture effects observed during rolling of ingots in a commercial mill. Plane strain tests can generate useful results only in the case of adequate choice of sample geometry.