A Buffer Power Source Based on a Supercapacitor for Starting an Induction Motor under Load
In the paper, a model of a three-phase frequency-controlled induction electric drive has been developed in Simulink Matlab 2019 (MathWorks, Natick, MA, USA). This model is mathematically converted into a two-phase model by transforming equations. It is proposed to compensate the voltage drop in the power system during start-up operation under load by using supercapacitors as a buffer power source. A block of supercapacitors was calculated. Simulation modeling was performed at a different voltage than the network. The diagrams of the transient processes occurring in the electric drive when the power supply is changed were prepared. It was found that such a principle of implementing an additional source of electric energy allows to start induction electric drives in areas remote from industrial networks without significantly affecting their static and dynamic characteristics.
Топ-30
Журналы
|
1
2
3
|
|
|
Energies
3 публикации, 60%
|
|
|
Renewable Energy
1 публикация, 20%
|
|
|
Protection and Control of Modern Power Systems
1 публикация, 20%
|
|
|
1
2
3
|
Издатели
|
1
2
3
|
|
|
MDPI
3 публикации, 60%
|
|
|
Elsevier
1 публикация, 20%
|
|
|
Institute of Electrical and Electronics Engineers (IEEE)
1 публикация, 20%
|
|
|
1
2
3
|
- Мы не учитываем публикации, у которых нет DOI.
- Статистика публикаций обновляется еженедельно.